Build a low cost chiller page 2
	To run your chiller fill the cage with ice AFTER it is installed in the cooler. If you try to lift the cage full of ice ouside of the cooler you will damage the cage due to the weight of the ice. The cage I built holds about 20 lbs. of ice. After the ice has been filled close the lid and  plug the fan into the power supply. Set your fog maching approx. 1"-2" away from the inlet pipe, this will allow the fog to mix with a little air on its way in and will start to cool the fog making your ice last longer. Plug in your fog machine and you're ready to go. You may have to set your fogger on some pieces of 4x4 to raise the fog outlet to meet with the chiller inlet. One thing to note, you must use a fog fluid that can be chilled or the fog will not lie low to the ground as wanted. Some fluids that I use are Roscoe Stage and Studio fluid and VEI Groung Fog fluid. If in doubt, contact the manufacturer of your fog machine for a fluid to use. If you want to direct the chilled fog to a location away from the chiller attach some 4" flexible vinyl dryer hose to the outlet. I hope this information will help you have a spookier Halloween this year, ENJOY!