set-port-address — Use this function to set the communication port address.
set-operating-frequency — Specifies the target operating frequency (in Hz). This
value is used to calculate the flash programming times and the ISP
programming delays.
set-flash-program-option —
Use this command to set the default OPTION register value when
programming a device.
set-flash-size —
Use this command to specify the size of the flash on the target
microcontroller.
set-flash-page-size —
Use this command to specify the size of a flash page on the target
microcontroller.
set-ram-pages —
Use this command to specify the number of RAM pages on the target
microcontroller.
set-pin-state-delay —
Use this command to specify the delay time between parallel port pin
state changes. The time is specified in nanoseconds.