Select the face as shown to drill the hole
|
Tushar Suradkar www.oocities.org/ProeGuruCool |
|
Feature - Create - Hole - Straight - Linear - Done Select the face as shown to drill the hole | |
|
To locate the hole, select face as shown Type distance of center of hole from this face Press Enter |  |
|
Select the other face as shown Type distance of center of hole from this face Press Enter click One Side and then Done Click Blind and then Done |  |
|
Specify Depth in the message area and press Enter Specify Diameter of Hole in the message area and press Enter Click OK in the HOLE:Straight dialog |  |
| Hole is created |  |