Step 1:  Supplies:  45 degree 3" PVC elbow X 4, 3" PVC pipe X ~5.5", chopping board X 1, 3" hubless rubber boot X 2, 3" screw clamp X 4, thread sealant/glue, caulking, air conditioning sheet filter, and an RU-3550 K&N Filter.
The chopping board (blue) was cut and fashioned as shown to fit the MAF sensor manifold.  An air bypass valve was cut into the PVC pipe with a rotary tool and a bit a time.  Each of the four holes is approximately 2" X 1.5" and is beveled for smoother airflow.  A rubber boot was fitted over the bypass and slant-cut against airflow in a crescent shape.  The resulting concave lip was pressed into the intake, creating a negative pressure sensitive port.  The boot was then secured with two screw clamps.

Slide 1 of 6