Archon with Trophy Rack
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Dark Eldar Conversions Archon with Trophy Rack |
||||||||||||||||||||
| Next | ||||||||||||||||||||
| Dark Eldar Conversions | ||||||||||||||||||||
| I decided to make my Archon model a little bit unique by adding a Trophy Rack. In a number of games the +1 Leadership has been the difference between passing and failing morale checks. After some searching I decided to modify one of the trophy racks that are normally mounted on the shoulders of Chaos marine terminators. I added some 0.060-inch polystyrene rods to the bottom of the trophy rack to extend it. The rods were appoximately the same diameter as the spikes in the rack. I drilled some 0.030-inch holes in the bottom of the trophy rack and the ends of the polystyrene rods. 0.030-inch pins (paper clip) and super glue were used to bond the polystyrene rods to the bottom of the Trophy Rack. I then drilled some 0.060-inch holes in the hair-piece of the Archon's helmet to fit the rod extensions from the Trophy rack. The rods were glued into place to mount the rack. QED | ||||||||||||||||||||
| Photos Section (click on thumbnail to enlarge it) | ||||||||||||||||||||
| Miniatures © Games Workshop 2003. All rights reserved. Used without permission - models painted by Dan Moore | ||||||||||||||||||||
|
||||||||||||||||||||
|
||||||||||||||||||||
| Front view | ||||||||||||||||||||
| Rear view | ||||||||||||||||||||