ONE INTO TWO #
2
Equipment Needed:
2 - 2 1/2” hose, 2 - 1 1/2” hose
1 - 2 1/2” and 2 - 1 1/2” combination nozzles
1 - 2 1/2” to 1 1/2” gated wye
1 - scissor type hose clamp
Water to be supplied from the pump discharge at 100 PSI
Fire Gear Needed:
Boots and Helmet
Number of People:
Five (5)
All
equipment will be placed inside the equipment area prior to the start of the
event. Five team members will
position themselves at the start line located 25’ from the discharge of the
engine. When the signal is given by the judge, they will proceed to the
equipment area, connect the two sections of 2 1/2” hose and the 2 1/2”
nozzle. Connect it to the water
supply and hit the center target. When
the target is hit, the hose clamp shall be properly applied to the first section
of 2 1/2” hose and the two sections broken down.
The gated wye, the two sections of 1 1/2” hose and the 1 1/2” nozzles
are then connected to the first section of 2 1/2” hose.
The hose clamp is then unscrewed and the two outside targets hit.
The time is stopped when both outside targets are hit.
The left target is hit by the left nozzle and the right target is hit by
the right nozzle. Hoses, nozzles,
and gated wye shall not be pre-connected prior to the start of the event.
All four lengths of hose are to be rolled with the male coupling on the
inside of the roll. Once the 2
1/2” discharge has been opened at the start of the event, it is not to be
touched during the event. If the
water is turned off at the 2 ½” gate instead of with hose clamp, it is a
15-second penalty.
Org. Georgia Muster Association
Updated 1999