All you need is a bucket and a bottle - 2 litter bottles work well.
Bucket filled with water.
Rest easy, the hard part is over.
2 litter bottle or any other type of plastic bottle will work.
Cut the bottom off.Step 3
The top to the plastic bottle.
Cut a hole
in the middle of the cap.
*note: for
those of you
who dislike using aluminum for your bowl piece, you can use a metal bowl
or anything else you can think of, but since many of you don't have
a bowl piece I have put the tin foil design down since everyone can do
it. Just make sure whatever you use that it is sealed good
so no air can get though and it should work
fine.
Tin foil enlarged
Poke holes in the tin foil with a needle. Then place the tin foil inside the hole in the cap. Make sure you leave a little cup for the weed to sit in
How to smoke
it:
Step 1
Put the bottle with no cap into the bucket of water.
Next screw the cap with the bud packed inside it, lightly on the bottle.
Step 2
Light the weed and slowly pull the 2 litter bottle from the bucket. This creates a vacuum and sucks the weed smoke in the bottle.
Step 3
BAMM...LOOK AT ALL THAT SMOKE.
Next, unscrew the cap. Be careful, it's probably hot. You can put a rubber band around it so it's easier to remove.
Step 4
DAMN NICE HIT. WAY TO GO GIRL.
Then put your mouth over the top of the bottle (with no cap) and push the bottle down into the water. This forces the smoke out of the bottle.
DON'T SUCK, JUST BREATHE IN AS YOU PUSH DOWN.
PERSONAL TIPS
- NEVER put the bottle into the water with the lid and weed already on, or else the wind will blow the weed out.
- put a visible tape at the bottom of the 2 litter bottle so you can tell when you are at the end of the line - good when you are stoned and can't see straight - contributed by me
-
and again something I already mentioned
but a thick rubber band around the cap makes it easier to remove
the cap, and never screw the cap on all the way. It's a bitch to
get it off when it's time for your hit. -contributed by me
Back to the Hit da bong 4:20!