pipes

Step One: Take 15.5 oz arizona iced tea can (that was just what i had)

Step Two: Cut top and bottom off of can so you have a cylinder with an open top and open bottom

Step 3: Cut cylinder in to half so you have two half-pipes resembling the letter U

Step 4: Take one "U" and cut out a circle, then cut a triangle out of that circle, this will enable you to make a cone shaped bowl, then cut off the tip to let the stuff go through. you might want to put a regular pipe filter in the bowl.

Step 5: take the other "U" and roll it into a cylinder of desired size and shape
(mine resembles a cone)

Step 6: Puncture a hole in the cylinder from step 5 about 5/6ths of the way away from the side you smoke from just big enough for the tip of the bowl to fit through then fasten them together with apoxy or a soldering iron.

Step 7: Pack the bowl, cover the open end and pull! (I will be adding pictures real soon)

Step 1: Cut a potatoe in half and carve out a little bowl

Step 2: Shove a pen through the side of the potato, right below the bowl you carved out, be sure not to mess up the bowl.

Step 3: Poke little holesin the bowl, then empty the pen and put it about half way through the potato.

Step 4: Fill the bowl and smoke!!!