GEARHEAD DETAILING TIPS
The Hard Stuff First
You should always start with the wheels fender welds  and tires , then clean engine compartment and move on to the car body.
Step one :Wheels and Tires

Use a good tire cleaner like Whestlys Wheel cleaner and spay all 4 tires and let sit while you clean the rims and wheel welds.

Use a good tire brush to clean the white walls or letters

Rinse clean. you are now ready to clean the engine compartment.
Step Two
Engine Detailing. coming soon
Rinsing:
Step Three:
Before you start washing the body of the car, you should rinse it down starting from the top of the car rinse in a horizontal ( left to right  and back to left) motion with the hose and work your way down to the bottom of the car.  This will remove any lose dirt and road film from the car.  The more you remove before you apply pressure with you hand the less scratches you will have on the paint surface.
WASHING TIPS:


Step four:
After rinsing the entire car, you are now ready to apply the car washing solution.
After mixing your car wash solution in a bucket you will start at the bottom of the car and work your way up to the top.
This does not feel natural  but you do this for a really important reason. 
Less scratches to the car suface!
If you start at the top as you wash down the dirt you have lifted will run down the side of the car and you will wash over it again and again adding more scratches to the car surface.

By starting at the bottom you will wash and remove only the dirt and road film under your mit or sponge .

Start at the front and wash around the entire car doing  small section at a time washing from the bottom up( one fender then the door et.) and rinse throughly from the top to the bottom as you did when you first rinsed the car.
Drying
Polishing