McTank ExRT’s are made of high strength Kevlar fabric and marine grade vinyl ester resin for uninterrupted service and high durability. Each tank is hand made to exacting quality and engineering standards. I have over 40+ years experience in fiberglass fabrication and development.

Current tank designs offer the traditional round bottom configuration and the euro style with flatter sides and bottom. The widths of all tanks are greater than OEM tanks and range from about 18 inches for a 5 gal. tank, to almost 20 inches for the 7+ gal. tank. Tank depth, at the sides will be from 2 to 4 inches lower than stock tanks, (horn relocation required).
The 'stretched euro' tanks are available to fit several seat configurations. Currently I have models for the stock seat, the Corbin Gunfighter and the Mustang Regal seats. Each model has two versions, a slightly convex curve sided model that carries upwards of seven+ gallons and what I refer to as the 'super-slim' euro stretch with a tapered side and a meager 6+ gal. capacity, I can supply 'top fitting shells' for the cost of two way shipping ($20 - $30). The fitting shells will give you a 'eyes on" feel for the tank

All tanks can be installed with minimal changes in the stock configuration. Due to the change in the tank exterior, two fuel petcocks are required, one for each side, tanks are supplied with ¼” npt female fittings. The fuel petcocks on the non-stretched tanks are positioned about mid-tank (lowest point) which requires approx. 6” of additional fuel line for each side. The stretched models have the petcocks positioned at the bottom of the 'tails' and the stock fuel lines are adequate. The only other requirement is the relocation of the horn (1400). The basic and the 'stretched' ERT’s are compatible with stock and aftermarket seats, although there may be a conflict with the sheetmetal 'neck covers'.
The all Kevlar construction body is currently made for a recessed cap. All tanks are built to accept the 2 1/2 inch 'aircraft style' flush bolt on gas cap kits, I can supply a locking chrome plated cap kit for cost ($75) or I can install cap kits supplied by you at no additional cost (kit required before fabrication).