Page 2 of My Car Install

Pics of My Car Page 2 While in the Install Process

This is where the insides of the enclosure have had Vboc added to them along with the enclosure all wired up. I used Senergistic Research wire for the tweet and mid, and Lightning Audio wire for the mid-bass. It will all be redone next season, so this is just temporary. You can also see that the door panel had been put back on, and I have to tell you that the thing will barely stay on the door is so thick now. Plus on top of that, each door must weigh about 15 pounds. You can barely shut them.

The enclosure after vinyl was added, factory carpet cut, and speakers installed. This is just temporary also, but I don't
know how long it will stay like this. In the near future I will be purchasing all new factory carpet (you can see I need it in other
pics) and since they always have to much extra, I will be covering the enclosures in it, and placing the speakers right in the
factory carpet. This will be for the nearest factory look I can get. I might also get someone to sew this all up before I by new
factory carpet if I don't get it before competition's start. (I will rescan this pic soon)

As you know, Camaro's are mostly hatchbacks. Well, in order to keep some sound in in the back, I figured I should take
the back panel off and sound deaden it too. This is a pic before it was done.

The above pic after I had applied VBloc to it.

In the Camaro the back seats on your sides have places for 6x9s. Again, here is this pic of before I took it apart and started some sound deadening..