There was in the German army an overall "quality control" department
that was responsible for devising ways to make the German armed
forces more efficient. By 1940, it became apparent to this section
that some form of a self-loading rifle with a higher rate of fire
was needed to improve the German infantry's combat efficiency. The
army issued a specification to the gun producers and both Mauser
and Walther submitted prototypes that were very similar. Both models
used a mechanism known as the "Bang" system (after its Norwegian
designer Soren H. Bang). In this system, gases from a fired bullet
was trapped near the muzzle and used to pull a piston that opened
the breech to automatically reload the gun. Springs then would
return the muzzle cone and piston to their original positions so the
cycle would continue. The Mauser model was shown unsuitable for
combat use and subsequently the Walther design was adopted. It was
put into production in 1941 as the Gewehr 41(W).
The Gewehr 41(W), however, did not perform very well on the
battlefield. The Bang system was too complicated and broke down
frequently under the stress and wear of combat. And the gun itself
was too heavy for handy use. Reloading the gun also proved difficult
and time-consuming. Since it was the only self-loading rifle
available to the German army, it had to be produced in numbers. And
even in the factories, the Gewehr 41(W) was hard to mass-produce.
In 1941, Germany invaded the Soviet Union. On the Eastern Front the
Germans captured many Tokarev 7.62mm SVT38s and '40s self-loading
rifles. The Tokarev rifle employed a much simpler but more effective
gas-operated mechanism, which was duly copied by the Germans into the
Gewehr 41(W). The product was the Gewehr 43. The Gewehr 43 was
immediately put into production to replace the Gewehr 41(W). The new
model was easier to produce in large quantities and was lighter and
easier to reload. As a result it was a popular weapon among the
troops. Many short-cuts were incorporated into the manufacturing
process. Sometimes wood laminates and plasitc furniture were used.
In 1944, a shorter version of the Gewehr 43 was produced, and it was
known as the Karabiner 43 even though it was only 50mm shorter.
Both the Gewehr 41(W) and 43 accepted the standard German 7.92mm
cartridge. This made the Gewehr 43 a very lethal sniper weapons, and
all versions were equipped with telescopic sights as a standard
accessory. The Gewehr 43 was excellent in its sniper role and stayed
in service for the Czech army for several years after the war.
Back to German Infantry Weapons Page
Back to Heer Page
Back to Homepage