| STRUT TOWER BRACE |
| The BMR Strut Tower Brace adds stability and performance with an OEM quality fit and finish |
| 2002 Firehawk Trans Am Engine Compartment BEFORE Strut Tower Brace Installation |
|
 |
 |
| Copyright 2004 OJC Photo Inc |
   |
 |
 |
 |
| Close up of factory Strut Tower Brace. The nuts must be removed to install the brace. |
|
| Using a 15mm Socket Wrench, remove each of 2 brass nuts on each side (L-R) |
|
|
| The entire contents of this website is protected by U.S. Copyright Law. Photos, text, captions, design are copyright (c) OJC Photo Inc. Opinions expressed herein are those of the webmaster. All photos are copyright embedded and can be traced. |
 |
 |
 |
 |
 |
| L- The Strut Tower Brace is form fitted for the Strut Tower shape. R- The BMR STB comes complete with washers to affix during installation. |
|
| Drop the Strut Tower Brace into position over the 4 Strut Tower black bolts on the left and right side. It will sit flush against the tower. |
|
 |
 |
 |
| L- Place one washer on each Strut Tower bolt R- Place one nut on top of washer on each Strut Tower bolt and tighten. |
|
 |
| STRUT TOWER BRACE INSTALLATION COMPLETE! |
 |
 |