Lever Installation Instructions
NOTE: INSTALL CABLE IN LEVER PRIOR TO PUTTING LEVERS ONTO HANDLE BARS.
1) INSERT CABLE INTO CABLE ADJUSTER
2) INSERT CABLE END INTO HOLE IN LEVER
3) PULL CABLE TAUGHT
4) SLIDE BRAKE LEVER ONTO HANDLE BAR
5) TIGHTEN THE TWO CLAMP SCREWS DO NOT OVER TIGHTEN AND TORQUE EVENLY
6) INSTALL CABLE ONTO BRAKES AS PER THE BRAKE MANUFACTURE
IMPORTANT!!!
PLEASE READ THIS:
NEVER RIDE WITH THE BRAKE LEVER LOOSE OR IMPROPERLY ADJUSTED. IF YOU ARE NOT SURE OR HAVE ANY QUESTIONS ON
HOW TO INSTALL BRAKE LEVERS OR THE BRAKES GO TO YOUR LOCAL BICYCLE DEALER AND HAVE HIM INSTALL
THE TECH LITE BRAKES LEVERS.
OFF ROAD RIDING IS AN EXTREMELY DANGEROUS ACTIVITY. TO PREVENT SERIOUS INJURY EXTREME
CARE MUST USED WHILE RIDING. YOUR BICYCLE MUST BE INSPECTED BEFORE EACH RIDE FOR PROPER OPERATION OF THE BRAKES.
IF YOU CAN NOT PROPERLY INSPECT YOU BIKE THEN HAVE YOUR LOCAL BICYCLE DEALER DO IT FOR YOU.
FAILURE TO PROPERLY MAINTAIN YOUR BICYCLE COULD RESULT IN SERIOUS INJURY.
IF YOU NEED HELP, EMAIL US WITH YOUR QUESTION