Here are some pics of a couple of Spyder TL's that I powder coated.  The Blue one is a standard TL with a 32 Degrees bolt which I converted to rear-cocking.  It has a BOA Concealer barrel on it.  The Green one is also a standard TL, with a shocktech rear-cocking bolt (you know, the one where you twist the end and you can remove it without removing the hammer?).  Funny thing about that bolt - the rear cocking part wasn't long enough - I had to make a new cocking pin to go on the back, as well as mill finger grooves in the back of the marker.  Unfortunately, with the sight rail on, the finger grooves do no good, so the sight rail has been removed.  If I decide not to put the sight rail back on, I may do some Shutter-esque through body milling.  It has a LAPCO Big Shot Stainless Steel barrel.  With both of them I discovered that you can replace the stock pin that holds the sight rail and back block assembly with an autococker push-pin.  This makes it much more convenient!  The powder coating turned out awesome!  The blue looks just like it was anodized!  The green is a metalic powder coat, and it looks a lot like a Spyder SE in color!