INSTALLING A RAIL, G2  FLASHLIGHT N HOLDER

CLICK HERE TO RETURN TO HOME PAGE

CLICK HERE FOR FLASHIGHT AND HOLDER WEB SITE.

I order both the flashlight holder and the rail from vikingtactics it was a combo deal best around too.

I order this from tapco it came with 2 rails and the hardware to install it.

I mess up on this 1st drill ,but if you click the pic I tell you how to do it right. IT worked fine ,but after installing the flashlight the bi-pod hits the back of the flashlight and doesn't allow the bi-pod to be raise.

Line the rail up so it slide into the stock grooves. Then mark it.

I used a hammer and gently hit the nut in the rail as shown in the pic.

Put the screw from the back as shown in pic and apply 1 drop on guntite.

This pic shows what the mount looks installed, pls click the pic and the red is the correct way to do it if you want to mount a bi-pod and be able to raise the bi-pod.

Use the the alien wrench to tighten the nut firmly.

COMPLETED RAIL, FLASHLIGHT HOLDER AND FLASHLIGHT. PICS BELOW