Tech-100 sights for the sks

Click here to return to home page

link for tech sights

link for shooting result of the tech-sights.

I can't thank you enough tech sights. It's been so easy to shoot my sks now ,and to get groups I would never even dream a sks could do. Your product is rock solid and works 110 percent better then stock sights. .  I can say to be honest I was scare to remove my latch and pin since I like my rifles in stock condition, but after my shooting test not only will I put your sights on every sks I shoot I wish I install these sights long time ago. If you own a sks install these on your rifle and enjoy shooting your sks the way shouldn't been in the 1st place.  Thanks Tech Sights...... Douglas

I'm so glad I order this. It's the front sight thats smaller then the stock one ,and its great for making tighter groups at the range and it WORKS.The one on the right is the one I order from tech-sights and it .047 and makes shooting the sks from 50 yards out a breeze. Why, because with the stock front sight, it covers smaller targets or hides them. With the tech sights fine front sight it allow you to see smaller target and does not hide them. Make shooting at the range a breeze , and your groups will be tighter.

This is the sight I order. Its the tech sight TS 100, and am so glad I did. Wow, not only is it rock solid it works ,and make it easy on the eye when aiming. The sights are like a M1 and theres no play in the rear sight when aiming like the stock sks ones with its V notch. What you see,, what you hit,, for me and my friends it was bulleye every time.

This is the only front sight tool a SKS owner should have. Do not buy the cheaper ones that break or bend. This is  about 5 bucks more but worth every penny. B-sqaure makes it...

Install the tech sights below

1st make sure your rifle is unloaded. I use a dremal tool and shave the pin off the cover latch and then pull the latch out. I try pulling the pin out but it was a waste of time, dremal that pin and get that sight on.

Use the T part of the tool and remove the old front sight. Then install the new .047 from Tech Sight.

Insert the screw thru the cover to hold the sight, then place washer.

Add the screw head, tighten and your ready to go. On the back on the Tech Sight is 4 alien screws to hold the sight too, but after the main screw was tighten it was already rock solid. So I tighten the alien screw very little.

Ok now your sights are done on your sks and ready to go. I shoot alot and been shooting for years and tried alot of products, this Tech Sight is worth every penny make already great rifle a perfect great rifle. Now go shoots some tigher groups and see for yourself.