Custom fuse and relay panel
	This is my adaptation of a panel from a kit offered by Advance Auto Wire (www.advanceautowire.com). The nominal location is under the battery box but I wanted it in the engine compartment for easier access. As I am not using an electric fuel pump and hence its relay, I was able to shorten the panel such that it fits as shown in the former location of the regulator and turn signal relay. As there are more wires than on  the original harness, and as they are a gauge or two thicker, the harness has been split and run through two holes in the firewall instead of one. For convenience I chose to use the bottom hole for the wires that route across the passenger compartment and come back out into the engine bay on the left side.
						In this view the routing of the harness along the right fender can be seen. It will be taped up, but wires ties are being used as an interim measure to keep it under control.