I just received my Wild Thing 2 Super Unlooper, now what do I need to do?

 

1-Download and install the Wildthing 3.0 software from our website.

.Click Here to get the software now.

2-Email us your unlooper serial number located on the card socket and request the current image.

3-Install the image as stated below:

The current image is betty christina s.img

Here are the instructions to load a new image into Wild thing 2.  
 
Save the new .img file to your hard drive.  REMEMBER where you put it! 
 
Open the WildThing 3.0 Software.

Go to the options menu and click setup. 

Click button #6 or any other button that you want to program.   An "Open" window appears that contains all your other .img files. 
 
Find the the img file you saved in step 2 and double click it.
 
Close the Wild Thing Software.  

Restart the Wild Thing Software, the new image should now be on button 6 at the far right.  

4-Load the new image to your card.

5-Reboot receiver as stated below before inserting your updated card.

Steps to reboot your receiver…

You must follow these or the card will not work when you get home.

Read entirely before starting. DO NOT INSERT CARD YET

Step 1-Turn receiver power off

Step 2-Hold down the channel up key and the power button at the same time….

Step 3-Wait for 10 seconds….keep buttons down

Step 4-Unplug receiver…wait 30 seconds….keep buttons down

Step 5-Plug in the receiver…..keep buttons down

Step 6-Wait 10 seconds….keep buttons down

Step 7-Release the channel up key and the power button

Step 8-Wait 10 seconds.

Step 9-Insert your satellite card

Step 10-Click clear on your remote.

Step 11-Start watching TV and have fun!!!!

 

Questions email to Dragon's Landing.