Parts List
Transistors C2 -- 5
Q1-Q2 SK3004 C3, C4 -- 0.02
Resistors (ohms) Miscellaneous
R1 -- 430 Loop Antenna -- 200 turns of #25
R2 -- 10k enameled wire in square loop on
R3 -- 330k wooden frame. See text for details
R4 -- 6.2K Switch -- optional on either side of battery.
Capacitors (uF) 9 volt battery
C1 -- 10 RCA Jack to output to stereo (optional)
The antenna is 200 turns of # 25 enameled wire rapped in a square over two 48 inch pieces of wood nailed together in an “X” shape. You can run any type of wire from the antenna to the receiver. Lamp cord from a hardware store or speaker wire works well. Mount the loop on a pole that can be rotated. Plug the receiver into a stereo amplifier and listen. If you are somewhat near any power lines, you will have to rotate until the Hum goes to its’ lowest volume.
You should then be picking up different pops and crackles. At different times of day there are different sounds produced do to a multitude of atmospheric conditions. Get used to the different noises that are common. You will be looking for any unusual sounds. Look outside if you do. It may be a UFO! If you hear Morse code, the Navy may still be using a 2 million watt transmitter located in Maine that transmits at 14.8kHz.
Click here to Go Back to the Detectors page