The Monitor Case
Now that I had all the pieces to go in the case, I had to figure out what I was going to do. If you've never seen the inside of a monitor without the works, here it is:
Note the serious lack of a "floor." Get out the cardboard to make a template and then some plywood to make a floor...
 |
I
think that floor came out pretty good (if I do say so myself)!
|
|
I was going to
put up walls but decided that it would take away from the fact that
this is a monitor, so I left them as they were. My sister has a website
so I decided to use her heading for the back wall:
|
 |
 |
I
wired underneath the floor for electric before I put down a "rug."
I even sent a wire up to the "ceiling" for a dome light.
|
|
You might be able
to tell in this picture, the wire is held down with duct-tape (it's
a personal joke between me and my sister)!
|
 |
Since my sister has a window in the room on the wall across from her desk, I had to make a cut-out for that, too. Making the frame was really a test - all those angles, ughhhhhh.