Relay

		3A SPDT Relay for driving lamps,solenoids etc
		Three screw terminals and three screw terminals for outputs

Mains Controllers

		Solid state relays for driving 240V loads
		Opto isolated zero crossing turn on
		Two screw terminal inputs and two screw terminal outputs

Seven Segment LED Display Boards

		Single or Dual digit display (please specify)
		9 or 10 wire connections (10 pin header configuration)

Liquid Crystal Display Module

		16 character two line display with full ASCII character set
		14 PCB pad connections

Dual Mosfet Controller

		Two MOSFETS on one board will switch up to 10A loads DC
		Six screw terminals

Stepper Motor Kit

		Stepper motor 60x60x40mm plus two Dual Mosfet Boards
		Six screw terminals

LED Display

Two LED's on a board - three screw terminal connections

Servo Driver

No extra hardware is required to drive a servo motor but some software mods are needed.

DC Motor Controller

		Controls 4 DC motors with drive voltages 2-6V and currents up to 1A
		Adjustable speed and direction under software control
		Add a position pot to create a servo
		Suitable motor and gearbox is also available

DC Motor and Gearbox

		3V to 6V 200mA to 800mA
		Adjustable speed from 10,000RPM to 4RPM depending on gears installed