Lund Vent Visor

These were given to me used. i had to remove old foam double sided sticky tape (took some effort)

clean surface where old tape was and clean the surface on door with alcohol.

apply new 3M super strength double sided foam sticky tape to the visors. trick here: the tape was twice as wide
as i needed it to be, so the cut the roll in half with a sharp serated knife first, while the tape was still on the roll.

i laid down the tape so it wouldn't stick out, the ends were trimed off to match the ends of the visor.

with the backing tape still on find optimal mounting location and mark
lower edge of visor location on rear of door with some electrical tape.

un-peel about 10 inches of backing tape off the rear of the visor.
position the visor exactly where you want it. stick it and carefully un-peel
the rest of the backing tape and push down on the tape to give it a good seal.



came out looking great, and now i can have my windows open a little in the rain.
maybe i can find a rear window set at a junkyard.

---