President George

CB-Radio

 

ALIGNMENT

 

TRANSMITTER ADJUSTMENT


Test equipment required:

       
Power Supply: 13,2 V DC Current Meter Oscilloscope RF Power meter
RF VTVM AF Oscillator FM Linear Detector Dummy Load (50 ohm)
AF VTVM      


Preparation alignment:

       
VR208 Clockwise    
VR205 and VR 206 Middle position    
VR207, VR201, VR202, and VR 203 Counterclockwise    
Mic gain Clockwise    
Meter SW RF    
SWR/CAL Volume Middle position    
RF Power Clockwise    
Test frequency 27.185 MHz    


Step Condition Adjustment Procedure
1 LSB 27.185 MHz
No Mod.
VR203 Remove the PB201
Connect a DC current meter to TP202 (+) and TP203 (-)
Adjust for 330 mA
2 Same as Step 1 VR201 Connect a DC current meter to TP202 (+) and TP201 (-)
Adjust for 85 mA
3 Same as Step 1 VR202 Connect a DC current meter to TP202 (+) and TP201 (-)
Adjust for 170 mA
4 LSB 27.185 MHz
Two-Tone
400 Hz and 2.500 Hz
1 mV Mod.
L221 Re-install the PB201
Adjust for maximum on the RF VTVM
Set the AF-oscillator, so that the output is less than 32 V
5 LSB 27.185 MHz
Two-Tone
400 Hz and 2.500 Hz
30 mV Mod.
VR208 Adjust for 25 V on the RF VTVM
6 SSB 27.185 MHz
No Mod.
VR209 Adjust the carrier leakade at LSB and USB become minimum and almost equal
7 AM 27.185 MHz
No Mod.
VR205 Adjust for 3.9 Watt on the WattMeter
8 AM 27.185 MHz
No Mod.
VR204 Adjust for RF Meter at "9" just light on
9 AM 27.185 MHz
1 kHz 30 mV Mod.
VR207 Adjust 90% negative
10 AM 27.185 MHz
1 kHz 3 mV Mod.
VR213 Adjust for Modulation Meter at "9" just light on
11 FM 27.185 MHz
No Mod.
VR206 Adjust for 3,9 Watt on the WattMeter
12 FM 27.185 MHz
1 kHz 30 mV Mod.
VR212 Adjust for +/- 1.9 kHz Deviation


#1999/DréCB {} 19MIR001 [] 27.805 Mhz./USB

-o- Member of the Free Radio Campaign -o-