Laserbeak

One day I decided I'd like to see G1 Laserbeak with a robot mode instead of a cassette, so I made one...from scratch. The vast majority was made from various sheet and strip styrene, the thrusters and guns came from Gundam bits, and both heads are epoxy putty. All joints/hinges were made using 1mm copper rod. Not really much else to say about the construction, except it took more time that I expected. Oh, 'Con symbols are Delta's repro-labels

Condor mode:
various shots, including comparison with actual toy

Came out quite show accurate, despite having to transform. The head's a bit too small, but it needed to be to fit between the thighs during transformation. The legs are a bit too wide apart, but again, its a side effect for transformation. Besides those two minor points, I'm really pleased with his condor mode. Oh, his head can move up and down at two joints, his feet can move side to side, and his wings flap a bit.

Transformation:
Yep, a photo guide, first time I've done one. It's a simple transformation, as would be expected of his size. I'm particularly proud of his arm/wing transformation joint, it gets both the arms and the wings where I wanted them in each mode, using a single rotating block as the center.

Robot mode:
His robot made is based off the G1 seeker jets, along with some bits of his BW counterpart. His proportions didn't come out quite like I'd hoped(low shoulders, legs look weird from the side), but I'm still pleased with it. As for poseability, his shoulders and hips rotate up and down, while his biceps rotate side to side (as need for transforming), and that's it.

So there he his, my second full-scratchbuilt Transformer, an improvement over Arcee I'd say. So, what's everyone think?