How to Polish your guns Internals

    Down below are the plans on how to polish the internals of your gun.  This will make your gun shoot and work smoother.  With less wear.

    The things you will need will be metal polish.  A good brand would be Mother's Mag polish which you can pick up at Wal-Mart or an auto shop, and some fine grit sand paper at least 600 grit or higher (the finer the sandpaper the better the polishing will work), and a cloth, and if you have a dremel tool you can use that.

    Take the sear, striker, and bolt out of your gun.  Take the sand paper and sand off just a little bit of metal on each part on every side, not to much or you will screw up your gun.  All you want to do is to sand off some of the gunk and buildup on your parts!  Just sand enough to get it smooth!  It should only take you about 5 minutes to sand all the parts!  Now put some polish on the parts and rub it around the entire part and then buff it.  You can use either a dremel tool or rag to buff the parts.  Oil and replace the parts.  You can do this on the inside of your gun if you choose, which will help out your gun also, and they do have gun cleaning kits that have parts to clean out the inside of your gun.  It is not necessary to clean and polish the inside of your gun!