New! Older projects are now shown on a separate page.
Taig Lathe Experiments
I 've had a Taig lathe for a few years now, but never really used it much. Recently, I added a quick-change tool post, a set of knurlers, a couple of dial indicators for precision work- turning it into very productive machine. Photo below shows a piece that has just been knurled- a neat little tool to extract Ronson gas filler valves on the fuel tanks on butane-fired locomotives. (Two finished ones sit on top of the lathe headstock.)
Live Steam "Victoria" Tram Locomotive
I recently finished my first scratch built live steamer. It is an O gauge, 16mm-to-the-foot scale model of the rather ugly tram locomotive built by John Slee & Sons of Earleston, Lancashire in 1879 for the Plynlimon and Hafan tramway in Wales. Apparently, it was a rather unsuccessful runner and was withdrawn from service not long after. It uses a Saito single cylinder oscillating engine and boiler as the power plant. I substituted a Cheddar gas burner for the alcohol one supplied with boiler. I added a Mamod reversing valve to provide direction and a certain degree of speed of control. Both axles are driven, using ladder chain, with a 7:1 reduction incorporated in the drive. The body is constructed from sheet brass (Walmart door kickplate), with a large number of 1/32nd" rivets used to keep it all together. Tenmille buffers, commercially etched plates and the traditional colours of the railway finish it off. Even with one tiny cylinder, it is capable of pulling an impressive load and runs of 20 minutes duration are typical.
![]()
The "insides", showing all it's mechanical gubbins. Locomotive Carrier
One of the problems with a live steam locomotive with a tender is to carry it easily form the workshop to the garden railway without damaging the hoses between the locomotive and the tender. First, you start with a rough sketch, then you make it out of oak and brass...Talyllyn Slate Wagons I recently completed a few Perfect World Talyllyn Railway slate wagons kit 16mm scale to complete a model of a typical Talyllyn pre-preservation train.
Back to Current Projects Page
Back to the Main Page