|
|
|
|
|
|
|
|
|
|||||
| There are a few things I have dreaded since I started this journey. One is cutting out the driver rebates, the other is joining two pieces of veneer. Anyways following the directions and allowing the veneer to overlap 1-2 mm let's see what happens.... | By pressing very hard on the overlap and follwing with the rubbing block this proved to be suprisingly easy! | |||||
|
||||||
|
||||||
| Preparing to cut out the rebates. Notice my attempt to reduce the amount of dust that enters the enclosure by taping a vaccume cleaner to the enclosure.... | ||||||