To override the control ATM address of an MPC or MPS, use the atm-address interface configuration command. Use the no form of this command to revert to the default address.
atm-address atm-address
no atm-address
atm-address Control ATM address.
The default is an auto-generated ATM address.
Interface configuration.
| Release | Modification | 11.3(3a)WA4(5) | This command was introduced. |
|---|
This command specifies the control ATM address that an MPC or MPS should use when it comes up; that is, when it is associated with a hardware interface.
The atm-address command overrides the default the operational control address of the MPC or MPS. When this address is deleted (using the no form of the command), the MPC or MPS uses an auto-generated address as its control address.
The following example specifies the ATM address for an MPC:
mpoa-client-config#atm-address 47.0091810000000061705b7701.00400BFF0011.00
The following example specifies the ATM address for an MPS:
mpoa-server-config#atm-address 47.0091810000000061705C2B01.00E034553024.00
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.