To modify the buffer size used to load configuration files, use the boot buffersize global configuration command. Use the no form of this command to return to the default setting.
boot buffersize bytes
no boot buffersize
bytes Specifies the size of the buffer to be used. There is no minimum or maximum size that can be specified.
Buffer size of the NVRAM
Global configuration
| Release | Modification | 10.0 | This command was introduced. |
|---|
Normally, the Cisco IOS software uses a buffer the size of the system NVRAM to hold configuration commands read from the network. You can increase this size if you have a very complex configuration.
The following example sets the buffer size to 64000 bytes:
boot buffersize 64000
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.