To configure the transmit buffer of a CES circuit, use theces max-buf-size interface configuration command. Use the no form of this command to delete the CES transmit buffer size.
ces max-buf-size size
no ces max-buf-size size
size Maximum size of the transmit buffer for the CES. Possible values are from 80 to 1520.
256
Interface configuration
| Release | Modification | 11.3 MA | This command was introduced. |
|---|
This command applies to ATM configuration on the Cisco MC3810.
Using this command, incoming bytes received on a CES port are buffered by the amount configured, and transmitted to the AAL1 process as a block of data.
This command is supported on serial ports 0 and 1 when theencapsulation atm-cescommand is enabled.
The following example configures the maximum CES reassembly buffer size to 1520:
ces max-buf-size 1520
| Command | Description |
|---|---|
| ces cell-loss-integration-period | Sets the CES cell-loss integration period on the Cisco MC3810 multiservice concentrator. |
| ces clockmode synchronous | Configures the ATM CES synchronous clock mode on the Cisco MC3810 multiservice concentrator. |
| ces connect | Maps the CES service to an ATM PVC on the Cisco MC3810 multiservice concentrator. |
| ces initial-delay | Configures the size of the receive buffer of a CES circuit on the Cisco MC3810 multiservice concentrator. |
| ces partial-fill | Configures the number of user octets per cell for the ATM CES on the Cisco MC3810 multiservice concentrator. |
| ces service | Configures the ATM CES type on the Cisco MC3810 multiservice concentrator. |
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.