To configure the ATM circuit emulation service (CES) type, use the ces service interface configuration command. Use the no form of this command to stop the ATM CES service type.
ces service structured
no ces service structured
structured Specifies that the ATM CES type is structured. Structured is the only option supported in this release.
Structured
Interface configuration
| Release | Modification | 11.3 MA | This command was introduced. |
|---|
This command applies to ATM configuration on the Cisco MC3810.
This command is supported on serial ports 0 and 1 when the encapsulation atm-cescommand is enabled.
The following example sets the CES service to structured for serial port 0:
interface serial 0 ces service structured
| Command | Description |
|---|---|
| ces cell-loss-integration-period | Sets the CES cell-loss integration period on the Cisco MC3810 multiservice concentrator. |
| ces clockmode synchronous | Configures the ATM CES synchronous clock mode on the Cisco MC3810 multiservice concentrator. |
| ces connect | Maps the CES service to an ATM PVC on the Cisco MC3810 multiservice concentrator. |
| ces initial-delay | Configures the size of the receive buffer of a CES circuit on the Cisco MC3810 multiservice concentrator. |
| ces max-buf-size | Configures the send buffer of a CES circuit on the Cisco MC3810 multiservice concentrator. |
| ces partial-fill | Configures the number of user octets per cell for the ATM CES on the Cisco MC3810 multiservice concentrator. |
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.