Use the clear controller EXEC command to reset the T1 or E1 controller.
clear controller {t1 | e1 } slot / port
clear controller {t1 | e1 } number
t1 Specifies the T1 controller.
e1 Specifies the E1 controller.
slot / port Backplane slot number and port number on the interface. See your hardware installation manual for the specific slot and port numbers.
number Network interface module (NIM) number, in the range 0 through 2.
EXEC
| Release | Modification | 10.1 | This command was introduced. |
|---|
The following example resets the T1 controller at slot 4, port 0 on a Cisco 7500 series router:
clear controller t1 4/0
The following example resets the E1 controller at NIM 0:
clear controller e1 0
| Command | Description |
|---|---|
| controller | Configures a T1 or E1 controller and enters controller configuration mode. |
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.