Use the clock source line controller configuration command to set the E1 line clock source for the Cisco AS5200. Use the no form of this command to change or remove the clocking source.
clock source line {primary | secondary }
no clock source line {primary | secondary }
line E1 line from which the clocking is taken.
primary Primary TDM clock source.
secondary Secondary TDM clock source.
Primary TDM clock source is taken from the E1 controller 0 on the Cisco AS5200.
Secondary TDM clock source is taken from the E1 controller 1 on the Cisco AS5200.
Controller configuration
| Release | Modification | 11.1 | This command was introduced. |
|---|
Configure the clock source line primary command on the controller that takes the most reliable clocking from an E1 line. Configure the clock source line secondary command on the controller that has the next best known clocking. With this configuration, the primary line clocking is backed up to the secondary line if the primary clocking shuts down.
The following example configures the Cisco AS5200 to use E1 controller 0 as the primary clocking source and the E1 controller 1 as the secondary clocking source:
controller e1 0 framing esf linecode hdb3 pri-group timeslots 1-23 clock source line primary ! controller e1 1 framing esf linecode hdb3 pri-group timeslots 1-23 clock source line secondary
| Command | Description |
|---|---|
| framing | Selects the frame type for the T1 or E1 data line. |
| linecode | Selects the linecode type for T1 or E1 line. |
Printed for apswan@ctr.ap.nic.in on Wed Mar 5 22:32:57 PST 2003
All material in this document copyright 2000 Cisco Systems, Inc. All rights reserved. No material may be reproduced or distributed without written permission of Cisco Systems, Inc.