3' - 3/4" CPVC pipe
3/4" CPVC coupler
Pipe Primer and Cement
Primer
Paint
Tools
Torch
(small one, don't need too much heat)
Vise
Drill Press
Grinding Bit
How To
Step 1
measure in on the pipe about 6 inches, make a mark
Step 2
Start heating up the pipe and bend it on the mark, only a slight bend not too drastick or the balls will break (try not to burn the pipe, [when you make black marks] or melt it for that matter)
Step 3
Now measure another 6 inches from your last bend, make a mark
Step 4
Heat the pipe up and bend it the opposite way of you last bend, still try not to burn the pipe
Step 4
Look at the new barrel you've created and cut it on one end so there is only 2 inches from a bend to the end of the pipe, and cut the other end so there is 4 inches from a bend to the end of the pipe
Step 5
Cement the coupler on the end that you cut to 4 inches.
Step 6
Grind out the inside of the coupler that attaches to the original barrel of the gun
Step 7
Prime and Paint