I thought I would toss in some extra pictures of the dash board since I spent so much time on it.
Here is how I used those switch brackets that came with the kit to support the dash on the bottom.
Of course it is not screwed in yet, but you get the idea.
Here you can see my vinyl cutting technique.
Oh that running stuff is none other then Gorilla glue. Be careful if you use that glue or you could become a permanant part of your car.
It was tricky holding down those tabs while the glue set. I used rubber bands and small blocks of wood to put some pressure on the vinyl and hold it in place without leaving marks on the other side.
| Home
|
Previous | Next
|