Home

Renegade Bearing Wheel Supplies needed: -Renegade bearing -White Renegade spacers -nut, bolt, lock nut, washers -dremel

Take a look at the nut assembly beacuse the bolt I bought was too long do I had to add a nut and washers to make a tight fit. Antoher thing is that my hardware store did not have hex head bolts so I settled for the round head ones.

In this pic I took the grinding tool on my dremel and I smoothed out the raised disc on the inner half my alxe assembly would fit tightly.

This portion is to make the bearing fit. First thing I did was take the bearing and put it in the Wheel, then assembling it with the axle. Tightening it to make an impression of the spacer is need to make the grinding part precise and simplier.

Once the impression is made it is time to take it apart and use the deburring tool to grind off a little plastic at a time and once you did it to both halfs reassemble the yoyo and give it a few throws. If the spacers do not fit or if the string slips take it apart and grind some more plastic off.

The washer is under the nut is there to protect the plastic where it gets crushed

Dremeling of the caps is needed to make room for the nut and bolt. A little putty is good to hold the caps in and the string is there to make taking them out easier.

There is one problem with my Wheels is that they are not take apart, so it is up to you to figure out a way. It requires a pliers and a screw driver to take it apart, but if you don't the the string caught there isn't a problem.  Good Luck!