Easiest Bearing Wheel mod

Equiptment needed: Wheel TL or Spintastics bearing set up axle small washers 3/8" drill bit 3/8" spade glue

Pics are a comin

First of all take the Wheel apart. Then drill down with the 3/8" drill bit until you break the flat area. This gives your spade a starting hole.  Then take the spade and drill down as far as you want. now your spacer should fit in there perfectly.  Take the axle and put washers between the axle end adn in half so the nut doesn't dent the plastic half. Glue the washers and nuts down. Take the 3/8" drill bit and drill in teh end cap so the nut will fit and the caps are flush with the yo.  I use silicon to glue the caps on so it will bond but still be take apartable when you need to tinker around with it. if you have any questions email me @ su_dc3@yahoo.com and I'll have pics up soon.