If you have a: YamahaCD burner and are trying to overburn, then you should make sure that you are using the newest Firmware .
If you have a: HP 7100 / Philips CDD3610 or a compatible device, then you should deactivate reading RAW data in the mode 2/XA mode
If you have a: Panasonic 7502 or Matsushita 7502 or a Plasmon CDR480is being used, the you should update to at least Nero 4.0.
If you have a: HP 8100, HP8110 or Sony CRX100, Sony CRX110 (or a HP 7500, Sony ROX5004) is being used, then this error message will appear if you try to burn a CD in the Format data-audio-data. The burner can not handle burning this format.
If you have a: HP 8100, HP8110, HP8200 or Sony CRX100, Sony CRX110, Sony CRX120 (or a HP 7500, Sony ROX5004) is being used, then the error message appears if you try to copy a CD on which the pause before the first track is more than 3s long. This is for example the case with all CDS which have a bonustrack before the first track . To find out if the CD to be copied is this kind of Cdcan be seen in CD-recoder->CD-Info. The start time of the first track is shown there.
If you have a: JVC XR-W4080, JVC XR-W4082, Creative CD-RW RW4224E, Hi-Val H4242, Memorex CDRW4224, RWD RW4224, or a Smart & Friendly CD-RW4224A in your possession and you have the overburn option activated, then the latter is the reason. You need a more up-to-date Firmware to be able to overburn. Please contact the vendor of your CD burner.
If you have a: TEAC CDR55S , then you should at least use Firmware 1.0j.
If you have a: Waitec 624 is being used, you will suddenyl be able to write as of Nero 4.0.3.0 CD-Text can write. This is only possible as of firmware 7.0j and not already with firmware 7.0f. This problem is solved as of a future Nero version.
If you have a: Smart & Friendly 6024 is being used, you will suddenyl be able to write as of Nero 4.0.3.0 CD-Text can write. This is only possible as of firmware 6.0j possible and not already with firmware 6.0f. This problem is solved as of a future Nero version.
If you are using a mainboard witha VIA chip set and the harddisk is being operated in UDMA mode, then you should change this. Please set the transfer mode to PIO in the BIOS.
If you are copying a CD then it is possible that the CD-ROM drive (some burners as well) read the media catalog number or the ISRC-information incorrectly and therefore the burner issues the above error message. Please deactivate the option Read the Media Catalog Number/ISRC in the Read Options.
This error message can appear if the SCSI cabling is not correct or the termination is faulty. But it could also be caused by drivers which have not been updated.
Please termination and check the SCSI cabling . And if necessary, download the newest driver for your SCSI controller and install it.