|
~Sodium Chlorate~WARNING! Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational/research purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
Discuss Anarchy >>>
Sodium Chlorate is a strong oxidizer used in the manufacture of
explosives. It can be used in place of Potassium Chlorate.
Material Required Sources
----------------- -------
2 carbon or lead rods (1 in. diameter Dry Cell Batteries
by 5 in. long) (2-1/2 in. diameter by
7" long) or plumbing
supply store
Salt, or ocean water Grocery store or ocean
Sulfuric acid, diluted Motor Vehicle Batteries
Motor Vehicle
Water
2 wires, 16 gauge (3/64 in. diameter approx.), 6 ft. long, insulated.
Gasoline
1 gallon glass jar, wide mouth (5 in. diameter by 6 in. high approx.)
Sticks
String
Teaspoon
Trays
Cup
Heavy cloth
Knife
Large flat pan or tray
Procedure
- Mix 1/2 cup of salt into the one gallon glass jar with 3 litres (3
quarts) of water.
- Add 2 teaspoons of battery acid to the solution and stir vigorously
for 5 minutes.
- Strip about 4 inches of insulation from both ends of the two wires.
- With knife and sticks, shape 2 strips of wood 1 by 1/8 by 1-1/2. Tie
the wood strips to the lead or carbon rods so that they are 1-1/2 incles
apart.
- Connect the rods to the battery in a motor vehicle with the insulated
wire.
- Submerge 4-1/2 inches of the rods in the salt water solution.
- With gear in neutral position, start the vehicle engine. Depress the
accelerator approx. 1/5 of its full travel.
- Run the engine with the accelerator in this position for 2 hours, then
shut it down for 2 hours.
- Repeat this cycle for a total of 64 hours while maintaining the level
of the acid-salt water solution in the glass jar.
CAUTION: This arrangement employs voltages which can be quite dangerous!
Do not touch bare wire leads while engine is running!!
- Shut off the engine. Remove the rods from the glass jar and
disconnect wire leads from the battery.
- Filter the solution through the heavy cloth into a flat pan or tray,
leaving the sediment at the bottom of the glass jar.
- Allow the water in the filtered solution to evaporate at room
temperature (approx. 16 hours). The residue is approximately 60% or more
sodium chlorate which is pure enough to be used as an explosive
ingredient.
|
Random
Link From Our Search Engine...Click Here!
