Home | Back

900 Series

1992 - 10,000 Mile Maintenance Service




Key recommended safety & operational services:

EVERY 10,000 MILES
OIL FILTER & ENGINE OIL: REPLACE
  • Every 10,000 miles, or every 6 months, whichever comes first.
  • If driving conditions are demanding, every 5,000 miles, or every 6 months, whichever comes first.
  • Vital to maintaining/prolonging engine life.
  • Keeps harmful engine-wearing deposits to a minimum.
  • Genuine Volvo filters with high filtration capacity and two special valves to reduce the risk of clogging.
  • Special sealing gasket and precision-cut threads secure the filter to prevent oil leaks.

    EVERY 10,000 UP TO AND INCLUDING 100,000 MILES:
    BATTERY TEST: CHECK ELECTROLYTE LEVEL-
  • Determines power level and possible need for replacement. Avoids inconvenient "no start" situation.
    BRAKE SYSTEM PRESSURE TEST-
  • Check fluid; inspect rubber and metal brake lines, couplers and master cylinder.
  • Contaminated fluid could damage components and cause braking inefficiency.
    BRAKE PADS: CHECK WEAR-
  • Worn-out pads will result in irregular braking, reduced stopping power and damage to rotors (discs).
    AUTOMATIC TRANSMISSION: ADJUST SHIFT CONTROL -
  • Reset to factory specs. to minimize transmission wear.
    KICK-DOWN CABLE: CHECK/ADJUST -
  • Ensures smooth shifting of transmission.
    COOLING SYSTEM: PRESSURE TEST-
  • Maintains proper operating temperature for longer engine life, avoids possibility of dangerous overheating and ensures proper heater operation.
    FRONT & REAR SUSPENSION: RETORQUE at 10,000 MILES, CHECK AT 30,000 MILES AND EVERY 10,000 MILES THEREAFTER -
  • Maintains integrity of steering and suspension components.
  • Assures proper wear.
    DIAGNOSTIC CODES: CHECK, RESET -
  • Identifies possible source of emission, drivability and fuel economy problems.
  • Clears codes for next scheduled service.

    20,000 - 40,000 - 60,000 - 80,000 - 100,000 MILES:
    AUTOMATIC TRANSMISSION (940 Models): REPLACE FLUID-
  • New transmission fluid aids in proper operation/prolongs transmission life.

    30,000 - 60,000 - 90,000 MILES:
    AIR FILTER CARTRIDGE: REPLACE-
  • New air filter cartridge helps maintain proper engine operation characteristics.
  • Reduces engine wear by properly filtering harmful dirt and contaminants before air enters the engine.
  • Maximizes fuel economy.
    BRAKE FLUID: REPLACE-
  • Old, possibly contaminated (w/ water) fluid could lead to brake problems.
  • Bleed system, fill with new brake fluid and pressure test.
    DRIVE BELT TENSION (940 Models): CHECK-
  • Ensures proper tension is maintained to operate alternator, A/C compressor and power steering.
  • Check for belt wear.
  • Replace worn belts to avoid belt failure while driving.
    ENGINE VALVES: ADJUST-
  • Maintains proper operating efficiency and smooth performance of the engine.
  • Improperly adjusted valves could cause excessive wear and shorten engine life.
  • Special shims and tools are required.
    SPARK PLUGS: REPLACE -
  • New spark plugs are specially designed and calibrated to provide optimum engine operation.
  • Engine is tested on special Volvo diagnostic equipment after spark plug installation.

    50,000 - 100,000 MILES:
    TIMING GEAR BELT (B230F, B230F Turbo and B234F ENGINES): REPLACE-
  • New timing belt helps prevent costly engine damage due to belt failure while driving.
    BALANCE SHAFT BELT: REPLACE - (B234F ENGINE)-
  • New belt helps avoid costly engine damage due to belt failure while driving.

    60,000 MILES:
    AUXILIARY DRIVE BELTS (B6304F Engine): REPLACE -
  • Replace worn belts to avoid belt failure while driving.
    FUEL FILTER: REPLACE -
  • New filter assures flow of properly filtered fuel to injectors.
  • Prolongs fuel system component life.
  • Helps maintain engine operating efficiency.

    60,000 - 80,000 - 100,000 MILES:
    PCV - FLAME GUARD: CHECK AND CLEAN -
  • Maintains proper emission control.
  • Clogged flame guard may cause oil seepage.
    EGR VALVE: CHECK AND CLEAN (B230F, B230F-Turbo and B234F engines)-
  • Removal of carbon deposits helps engine run clean.
  • Maintains proper emission control.

    70,000 MILES:
    TIMING GEAR BELT (B6304F engines): REPLACE, LUBRICATE tensioner pivot bearing-
  • New timing belt helps prevent costly engine damage due to belt failure while driving.

    Complete value-added services:

    EVERY 10,000 MILES UP TO AND INCLUDING 100,000 MILES:
    CHECK:
    Parking brake Lighting controlsWindshield wiper/washerEngine
    Transmission Clutch adjustmentTiresRear axle
    Exhaust systemPropeller shaft, U-joints Fuel hoses and pipes Reset service reminder indicator

    LUBRICATE:
    Hood hinges
    Door hinges, stops, striker plates
    Power antenna: clean & lubricate


    20,000 - 40,000 - 60,000 - 80,000 - 100,000 MILES:
    CHECK:
    Steering gear Control arm bushing, front and rear shocks: Retorque at 20,000 miles, check at 40,000, 60,000, 80,000 and 100,000 miles


    30,000 - 60,000 - 90,000 MILES:
    CHECK:
    Steering gear play/effortWheel bearing playBall joints
    Stabilizer bar and linksPropeller shaft, support bearingsSteering rod ends, tie rod ends