Question 1:
A VLAN is based on which type of grouping?
A. Logical
B. Physical
C. Star
D. Ethernet
Question 2:
What is a VLAN used to create?
A. Autonomous systems
B. Broadcast domains
C. Network Sectors
D. Virtual sections
Question 3:
Users may be reassigned to different VLANs using which of the following?
A. Hubs
B. Software
C. Routers
D. Bridges
Question 4:
What is a benefit of using VLANs?
A. Extended collision domains
B. Increased administration
C. Multiple cable runs
D. Tighter network security
Question 5:
What would be the preferred type of link of a VLAN backbone?
A. slow serial
B. low capacity
C. 56 Kbps
D. High bandwidth
Question 6:
Which technique examines particular information about each frame?
A. Latency
B. Frame resolving
C. Frame filtering
D. Store and forward
Question 7:
According to the IEEE, what is the acceptable way to implement VLANs?
A. Grouping
B. Filtering
C. Source bridging
D. Frame tagging
Question 8:
Frame tagging functions at what OSI layer?
A. 2
B. 3
C. 1
D. 4
Question 9:
Frame tagging places a unique identifier in the header of each frame as it is
forwarded across the network __________.
A. microsegment
B. LAN
C. backbone
D. WAN
Question 10:
Which of the following do VLANs use to make filtering and forwarding decisions?
A. Packets
B. Frames
C. Presentation header
D. Network design
Question 11:
What technique does 802.1q use to implement VLANs?
A. Grouping
B. Filtering
C. Source bridging
D. Frame tagging
Question 12:
A VLAN makes up a switched network that is logically segmented by all of the
following EXCEPT :
A. Collison domains
B. Functions
C. Applications
D. Project teams
Question 13:
What term describes all nodes on the same VLAN ID that are attached to the
same switched port?
A. Dynamic
B. Static
C. Port-centric
D. Static-centric
Question 14:
What is the term used when ports on a switch are administratively assigned to a
VLAN?
A. Dynamic
B. Static
C. Default
D. Polled
Question 15:
Which of the following VLAN types require changes by the network administrator
but are easy to configure, and straightforward to monitor?
A. Dynamic
B. Static
C. Cut-through
D. Store-and-forward
Question 16:
What is the term used when switch ports are automatically assigned to a
VLAN?
A. Dynamic
B. Static
C. Port-centric
D. Default
Question 17:
Dynamic VLANs can be based on which of the following?
A. MAC addresses
B. Protocol type
C. Logical addressing
D. All of the above
Question 18:
When logically segmenting your network with VLANs, what type of device do
you need to ensure proper communication between the VLANs that are created?
A. Switch
B. Bridge
C. Hub
D. Router
Question 19:
What is an effective preventative measure used with segmentation to prevent
broadcast related problems?
A. Firewalls
B. LANs
C. WANs
D. Bridges
Question 20:
Which device is used to reduce or eliminate broadcast related problems?
A. Bridges
B. Routers
C. Passive hubs
D. Active hubs
Question 21:
VLANs, along with routers, establish which of the following?
A. WANs
B. LANs
C. Broadcast domains
D. Collision domains
Question 22:
The smaller the VLAN, the smaller the number of users that are affected by
which of the following?
A. Packet filtering
B. Switch latency
C. Framing
D. Broadcasts
Question 23:
How can access be controlled on a secured VLAN?
A. Station address
B. Protocol types
C. Application types
D. All of the above
Question 24:
The individual ports of a non-intelligent hub can be assigned to how many
VLAN(s)?
A. Three
B. Two
C. One
D. None