Note, this as been copied and pasted directly from the SP3 manual as a quick reference, I did not write this. AGM-65 "MAVERICK With SuperPAK come various enhancements to the operation of the AGM-65: Mavericks need to be powered on before they can display an image. Power is either applied through the PWR Button (OSB 7) on the SMS page, or with STBY (OSB 7) on the WPN page (will then change to OPER). They take about 5 seconds to cool down. During cooling "NOT TIMED OUT" will be displayed. To see the image from the Maverick's seeker head on the MFD, change to the WPN page. Then, each time a AGM-65 is selected, it needs to be uncaged [u] in order to receive an image from the seeker head (This simulates removing of the seeker cover). The box around the crosshair is the narrow FOV indicator. The pinky switch toggles FOV. The gimbal cross indicates if we have a lock or not: Steady cross: Locked and within gimbal limits Flashing cross: No lock or approaching gimbal limits RALT readout displayed (if enabled) TMS-Left toggles display polarity between HOC and COH (N/I) In addition, Submodes have been modeled (not all complete): PRE for preplanned targets: Radar will start in GM, the Maverick is slaved to the radar. Once designated, a steering line is displayed (same as CCRP). VIS for visual targeting: Missile starts in Boresight, Radar is in AGR. - Predesignate: the seeker position indicaator is a square - Postdesignate: the seeker position indiccator is a circle. BORE is the same as VIS. MISSION SP24: AGM-65 MAVERICK MISSILE Load the default Falcon 4 training mission 24 to practice the new deployment procedures. Use the following procedure to properly set up your cockpit: When the mission begins, set the Master Arm switch [Shift-m] to ARM (so you can fire) and select A-G [Shift-Num-.] as your master mode (you want to attack ground targets). Select the FCR page in your left MFD and the SMS page in your right MFD (using the OSBs 12/13/14). On the SMS page, switch to the AGM-65 missile (OSB 6) and power it up (OSB 7). Switch to the WPN page on the right MFD (OSBs 12/13/14). On the FCR page (in your left MFD), set your radar mode [F2] as required (GM/GMT). Now you can choose your target area: Still on the radar screen, slew the radar cursor over your target [Cursor keys] and designate it [NumKP-0]. The SOI (Sensor of Interest) now changes to the right MFD. Finally, it's time to ready the missile and launch it: Uncage [u] the missile (this removes the protective lens cover from the AGM-65). You can now see the target area that you designated before. Slew the video cursor [Cursor keys] (use EXP mode [Shift-v or OSB 3] for zoom view) and lock it onto the final target [NumKP-0]. Check weapon range. Pickle to launch the missile [Space]. Repeat these four steps for each additional missile that you want to fire into the target area. If you want to attack a target further away, undesignate the current target [NumKP-.] and return to search mode. The pictures on the right depict the 3 stages of the WPN view: caged (no video available yet - uncage the missile!), uncaged (slew with cursor to target) and locked (target has been designated).