Griffin Platinum

Griffin Platinum is a special tool to assist in phone repairing process. It is upgradeable and it can do far more than only repairing flash or unlocking Nokia phones. Take a closer look on how this New Griffin Platinum can help you further. For example, it can help change language, upgrade firmware and tune on almost all Nokia settings like Product code, networks values, backup/restore user settings, sms... and many more. The different between the (plastic, silver and gold) Griffin and The Griffin Platinum are that the box has bigger fan to cool the CPU inside and it has on/off power switch as this can help to extend the life of your Griffin Box. Now Griffin Platinum can also support IMEI repair on Nokia phones, as in the case where the UEM of the phone has been changed (with empty).
Griffin 2.07 Released 23-12-200
-Faster unlock of DCT3 and DCT4.
- Highly flexible interface for LOCK Nokiaa phones.
- Selectable Backup of user data from DCT44 phones(asic2)
- Refined interface for IMEI Ask read.
> - Change to NKCC support so it generates ccorrect unlock codes for keyboard.
In general - Small change to make a big improvement.

Griffin Flasher, CRD and Clip 03-12-2003
1. Griffin Flasher:
Change made so griffin reads correct ask files from WD2 phones( asic5), NOTE imei still needs to be entered manually as it is not read from UEM. Implemented support for Nokia 7250i repair ( contact service problem after changing flash chip, or flashing with wrong flash file). Also the possibility to upgrade 7250 to 7250i.
2. Griffin CRD: Version 1.082 released In it we added support for new Siemens phones C60/A60 (TEST POINT SOLUTION).
3. Griffin Clip ( GT-CL1):Support for siemens A60/C60 through testpoint. Change too nokia code calculation so it works on new nokia models (1100,3200…..).
Case 1: UEM chip is ok and contains valid IMEI, then it is needed to compute the IMEI data for flash - Click read data, send the file to ron2pet@Hotmail.com and I will send you RPL file for IMEI data in flash, send the received RPL file to phone using WriteData. After that you phone should be working again. And the good news is that you have repaired the phone without changing the IMEI ( which is illegal in many countries). (when griffin reads ASK file it will show the IMEI that it read from UEM, before you send the file for computation check if the shown imei is 14 digits. Only in this case we will be able to compute correct RPL)
Case 2: UEM chip is damaged so you need to replace it. In this case the phone will have ?????????????? for IMEI because UEM is not initialized and contains 000000000000000 for IMEI. You have two possibilities in this case. Write any RPL to phone and the phone will contain the IMEI that was in RPL file. But this will cause the phone to have different IMEI then the one that it originally had. As mentioned above this is illegal in many countries and it is risky to repair the phone in this way because you can end up in jail. If you wish to initialize the UEM with the specific IMEI, enter the IMEI you wish us to compute in the IMEI/ESN field and read log from the phone ( note: if you correctly replaced the UEM with new empty one, the IMEI read from UEM will be 000000000000000, only in this case the IMEI we compute will be correctly stored in UEM when you send the RPL file to phone).

NOTE 1: The computation of RPL file will not be FREE. You will need to pay for the computation, but this is only because nice things cost money.

 

For purchasing and direct ordering of the product and more information, email me at ron2pet@Hotmail.com