DIY Oil CatchCan
Parts Needed:
1. Empty 134A can
2. Valve cover Breather
3. 1/8" Brass plug
4. 3/8 NPT brass fittings from Home Depot x 3 (This will be for 1/2" hose)
5. Drill with Unibit

Directions:

1.  Drill two holes on the side of the can where you see the yellos holes.  this is where the hoses will connect from the back of the block.
Screw the two 3/8" fittings there

2.  Drill one hole on the bottom of the can, put the last fitting there and clean can of any metal debris from inside.  Attach the filter on the bottom of the can like pic. 

3.  Finally with the 1/8" NPT you will plug up the top of the can. (This is where the Refrigeriant used to come out of)  Now the top of the can becomes the bottom and the bottom becomes the top.

4.  Your done, install in car and thats it.
                                                                                                                             HOME