 |
 |
 |
| CUP HOLDER |
| This cup / can / bottle holder ( Helping Hand Cupholder ) was obtained from Custom Fabrications cost was $25.00. Below is a few pictures of the install. It was real easy and took about 15-20 min. Tools needed were drill, 1/4 drill bit, phillips screwdriver and wrench. The cup holder folds flat up against the glovebox when not in use. |
| Hold or tape templete in place and mark hole locations |
| Drill Holes ( can be done on left or right side of glove box by simply flipping the template. ) |
| Place backing plate on put on nuts and bolts / etc. Good /Full instruction come with the kit. |
| Cup holder folds flat when not in use. It is adjustable to fit various sizes of cups / cans / bottles. |
| Click on pictures for larger view |
| Click on pictures for larger view |
| Click on pictures for larger view |