Magazine Coverage    Tech and Links  New Motor  Roll bar and Misc  Polishing made easy

Here are some pictures of my recent rollbar installation. I had a custom made chrome moly 6 point rollbar with 2 swingouts fabricated by Willie Rells Racecars in San Diego Ca. total cost was $600 for the bar, $100 for powdercoating $40 for the quick disconnect pins and $169 for the harness. This car is 90% a street machine so I wanted a bar that would be protective and also be pleasant to the eye and not detract from my cars looks when the top is down.

This is the first try and trial fitting of the bar, the rear support bars were not what I had envisioned and were going to be altered to hide the bend below the body line.

Now this is a little better, notice how the back bar is now bent below the body line. The swingout was also installed. Now we ran into a problem that the cross bar under the main hoop needed to be taken out and curved for better seat movement

Here is the finished product ....looks pretty good.

September 1, 1999

Here are some recent pictures of the cobra rear bumper and new Cervini Stalker front