 |
| Hear are the carb & exoust pipe |
| The carb. is built from plans printed in S.I.C. magazine ( see links) and is made from 3/4(.750) X 3/4 360 brass. It is a two jet carb. with throtel ! |
| The exoust pipe is just a peice of 5/16(.3125) thick wall brass tubing bent and threded 5/16 24 nf on one end . |
 |
| The timing belt and timing pullyes are stock parts from MSC pullyes have had the hubs removed and set screw holes drilled & taped in the center of the actual pullys , and have had keyways cut for round keys The ideler pully is just made from scrap alu.,brass, and steel ,and another ball bearing from a diegrinder |
 |
| This is what i have gotten done on the water pump so far . The gears are from a cordless drill planetarry set and have ben ground to .193 for now but will get ground more latter after i cut the pockets in the housing for them. The housing is 3/4 X3/4 360 brass ( same peice used for the carb. and all the brass on the maverick) |
 |
| This is my first try at building a radeator , but i think it turned out OK! the tanks are made from reshaped brass tubing , the cores are just 1/8 in brass tubing as is the overflow , the fins are .005 brass sheet ( next time I will use .010 or .015) the end plates/stands are .030 X .750 brass plate bent into a "U" beam shape , the inlet & outlet are just 1/4 in OD. brass tubing. The part that gets the most att. when i show it to others is the cap and filler neck. I decided to make a 1/4 turn cap for it and it turned out great!!!!!!!!!!! |
| MORE TO COME AS SOON AS IT IS FINISHED! |