If you are getting "clicks" in your output when going into play or stop mode,
try the following:
Open the DriverLink (in the Multi!Wav program group) and click on the Options tab.Uncheck MONITOR INPUT SOURCE.
Uncheck SYNC PLAYBACK TO EXTERNAL CLOCK.
This might solve your problem. When you MONITOR INPUT SOURCE you are locking to an incoming signal (or none, if there is no incoming signal). When you switch to playback you change to internal clock, thus the click.
If you want to monitor the input, and are certain there will always be a signal at the input to the card, then you can select BOTH MONITOR INPUT SOURCE and SYNC PLAYBACK TO EXTERNAL CLOCK and there should also be no click. If you select ONLY MONITOR INPUT SOURCE, then there will many times be a click when entering play as the clock switches from external to internal.
Multi!Wav Support Home | Multi!Wav Knowledge Base | Multi!Wav Drivers & Software
AdB and Multi!Wav are trademarks of AdB International Corporation. All other products are registered trademarks or trademarks of their respective companies. © 1999 AdB International Corporation. All rights reserved. Terms of Use.