The Sketchbook 2
Home Information First Aid Do It Yourself Sketchbook Part 1 Part 2 Part 3 Part 4 Part 5 Part 6 Tools Tricks & Tips Knowledge This & That Links Last Update 10 July 2001 © RubberHans Send Mail			How to Fit a String In case you just do your first latex panty and you possibly feel somewhat unsure about the measures you took, cut the string some cm longer than expected. Now put on the slip and adjust the string and pull it tight. Indicate the upper edge of the belt at the string. Glue the string and finally cut it parallel to the belt's upper edge. Variants to Tailor Strings Many variants can be done, which can be used not only for slips, but for body suits or other garments as well. Completely closed. Slips of that type will give a very intense latex feeling, particularily when worn as underwear under allday's clothing. But if you intend to have fun at sex with them, then they may be an obstacle... An opening at the front or lower part can reduce the obstacles. The opening should be reinforced by a ring of rubber or leather glued to the inner side to improve stability. For a gentleman's slip, cut the opening that way: Measure the circumference u of the erected penis below the testicles. For this, pull the tape-maesure a little tight. The diameter of the opening then should be u/3 Douple straps allow free sight and access to the most intimate parts of the body. Unfortunately that type of strap only gives reduced intensity to experience the rubber feeling. A good countermeasure are additional soft strips of latex which can be buttoned to the waist belt. The back can easily be done with a simple strip of latex or rubber. If you plan to wear this type of slip as everyday's underwear, you should not glue the strip too tight as it can be a nuisance after some hours. The solution with two straps can be continued at the back Very special add-ons like dildos or the unconventional arrangement of openings may support considerable lust experience. As these special devices and their arrangement are very individual to the person for whom the particular slip is made, this type of slip should be manufactured very precisely. The art to compromise between lust and nuisance somteimes can be difficult! Due to high tension in any case the strip between the legs should be made of three layers. The structure is latex-cloth-latex. In this case "cloth" is a reinforced rubber cloth. If there is the desire to tighten the slip sharply, use the well known belt-principle for waist-belt and strip between the legs. Alternatively, the belt can be planned as a type of corset. Headline text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text text